| Size of valve actuator | 18000 |
| Flange hole pattern | F30 |
| Piston diameter | 335 mm385 mm435 mm485 mm535 mm585 mm |
| Swivel angle | 90 deg |
| End-position adjusting range at 0° | -5 deg … 5 deg |
| End-position adjusting range at nominal swivel angle | -5 deg … 5 deg |
| Depth shaft connection | 200 mm |
| Standard connection for valve | ISO 5211 |
| Cushioning | No cushioning |
| Mounting position | AnyHorizontal |
| Mode of operation | Double-actingSingle-acting |
| Structural design | Scotch yoke system |
| Position sensing | Optical |
| Closing direction | Clockwise closingCloses to the left |
| Symbol | 0099126500991266 |
| Certified for safety function to ISO 13849 and IEC 61508 (SIL) | Product can be used in safety-related parts of control systems up to SIL 2, low demand |
| Operating pressure | 0.1 MPa … 0.85 MPa |
| Operating pressure | 1 bar … 8.5 bar |
| Operating pressure | 14.5 psi … 123.25 psi |
| Nominal operating pressure | 0.3 MPa … 0.6 MPa |
| Nominal operating pressure | 3 bar … 6 bar |
| Nominal operating pressure | 43.5 psi … 87 psi |
| CE marking (see declaration of conformity) | as per EU explosion protection directive (ATEX) |
| UKCA marking (see declaration of conformity) | acc. to UK EX instructions |
| Explosion prevention and protection | Zone 1 (ATEX)Zone 2 (ATEX)Zone 21 (ATEX)Zone 22 (ATEX) |
| ATEX category gas | II 2G |
| ATEX category for dust | II 2D |
| Type of ignition protection for gas | Ex h IIB T6…T4 Gb X |
| Type of (ignition) protection for dust | Ex h IIC T85°C…T105°C Db X |
| Explosive ambient temperature | -20°C <= Ta <= +80°C |
| Operating medium | Compressed air as per ISO 8573-1:2010 [7:4:4] |
| Information on operating and pilot media | Operation with oil lubrication possible (required for further use) |
| Corrosion resistance class (CRC) | 0 – No corrosion stress |
| Degree of protection | IP66MIP67M |
| Ambient temperature | -20 °C … 80 °C |
| Note about the torque | The actuator’s operating torque must not be higher than the maximum permissible torque listed in ISO 5211, based on the size of the mounting flange and the coupling. |
| Max. output torque | 18000 Nm |
| Product weight | 259 g … 856 g |
| Shaft connection | V72 |
| Pneumatic connection | G1/2G1 |
| Note on materials | Contains paint-wetting impairment substancesRoHS-compliant |
| Material of end caps | Steel |
| Stop screw material | Steel |
| Bushing material | BronzePTFE |
| Seals material | NBRTPE-U(PU) |
| Material of spring | Spring steel |
| Spring rod material | Steel, hard-chrome-plated |
| Housing material | Steel |
| Material of piston | Steel |
| Piston rod material | Steel, hard-chrome-plated |
| Tie rod material | Steel |
| Material of cylinder barrel | Steel, nickel-plated |
Reviews
There are no reviews yet.