Monitoring Ammonia in animal barns with long-term stability. Possibilities of extension: Measurement of Carbon dioxide (CO2), temperature, relative humidity, absolute pressure, Switching between two measuring points.
Aspirated system for one or two measured gases: sampling of measured gas and transmitter combined in one wall mounted housing. Continuous sampling and measurement.
Monitoring of air inflated membrane systems at Biogas Plants: Cost efficient solution for membrane systems with dynamic pressure at the blow-off end. Early recognizing of leakages, in order to avoid cost due to gas loss and danger for staff, plant and environment..
Evaluation of measuring signals and release of operating commands. The extension of the control unit software integrates the control and monitoring of the components for sampling and preparation of measured gas. It is possible to integrate even external transmitters into the system without additional expenses, for example for monitoring ambient air.
ET-1D is the best choice for all measuring tasks with only one measuring point. Our ET-1 offers all advantages of the Control Unit ET-8D, but reduced to one measuring point.
The Control Units of the Series ET-2D are a compact and easily understandable system for up to two transmitters which covers also complex monitoring tasks.
The Control Unit ET-4D2 is the best choice for limited measuring tasks which mainly require safety warning at a low cost level.
The control unit ET-8D is a compact and easily understandable system for up to eight transmitters. By means of its interfaces it is easy to integrate even in higher control and management systems.
Transmitter for measurement of ammonia in fluid mediums, for example in cooling soles, with integrated display for indication of measured values and relays outputs for Alarm and Fault.
Transmitter for pH measurement of ammonia in fluid mediums, for example in cooling soles, with integrated display for indication of measured values and relays outputs for Alarm and Fault.
Transmitter for flammable gases, toxic gases or oxygen. 4…20 mA-output with linear curve. The Transmitters of the ExSens(-I) Series are suitablefor use in hazardous areas of Zones 1 and 2
Transmitter for flammable gases, toxic gases or oxygen. 4…20 mA-output with linear curve. The Transmitters of the Sens(-I) Series are suitable for use under normal industrial conditions – mainly outside hazardous areas.
For your specific needs: E.g. visualization of measured values, messages and state of device (measured data) of up to 16 Gas Warning Control Units of the Series ET-8D on the monitor of a connected PC at the same time
